3-3. Adjusting the height of the knee lifter
1) The standard height of the presser foot lifted
using the knee lifter is 12 mm.
2) You can adjust the presser foot lift up to 13
mm using knee lifter adjust screw
1
.
D o n o t o p e r a t e t h e s e w i n g
machine in the state that the
presser foot
3
is lifted by 12 mm
or more since the needle bar
2
comes in contact with the presser
foot
3
.
3-4. Installation of thread stand
Assemble the thread stand, set it up on the machine table using the installation hole in the table and
tighten nut
1
gently.
When you use power supplied by the overhead power line, pass the power supply cord through hollow
spool rest rod
2
.
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
2
3
1
1
2
To Next Page
Loading...
Need help?
General
