107
1
2
4
3
3
WARNING :
To avoid possible personal injuries caused by movement other than that you desired, do not operate
the switches in the procedure other than those required, as described below, to specify the functions.
Do not perform switch operations other than those described in the following explanations.
Be sure to re-turn the power switch ON after one second or more has passed. If the power
is turned ON immediately after turning it OFF, the sewing machine may not work normally.
In this case, turn ON the power again.
6-17. Setting for functions
(1) How to change over to the function setting mode
2) Press switch 1 for
approximately three
seconds.
3) Press switch 2 for
approximately three
seconds.
4) This screen is the function
setting screen.
Change the setting No. with
“+/–” Key of switch 3.
For the details of setting
No., see P 110.
Example) Changing the
flicker reducing
function (Setting
No.
5)
Change the setting No. to “5”
with “+” Key of switch 3 in the
figure above.
・Press switch 4.
Setting No. Set value
There are two kinds of function settings, Level 1 and Level 2.
Level 1 : Change of setting can be performed without turning OFF the power switch.
Level 2 : It is necessary to turn OFF the power switch after change of setting.
For the details of setting No., see p110.
[Setting procedure of Level 2]
1) Turn ON the power. When the needle bar is not in its UP position, turn the handwheel to bring the needle bar
to its UP position.
Cau tion
To Next Page
Loading...
Need help?
General
