103
(3) Communication mode
The matters below can be performed in the communication mode.
1) Vector form (VDT) data can be registered to non-registered No. of custom pattern from the sewing machine
data server utility (hereinafter called SU-1) or the smart media.
2) Custom pattern can be changed to the vector form and be uploaded to SU-1 or the smart media.
3) Parameter data (EPD) can be overwritten and registered to the condensation custom pattern from SU-1 or
the smart media.
4) Condensation custom pattern can be uploaded to SU-1 or the smart media.
* For setting of the communication with SU-1, refer to the Instruction Manual for SU-1.
■Communication setting screen
1
2 63
[Maintenance personnel level]
1) Turn ON the power. When the needle bar is not in the UP position, turn the handwheel to bring the needle
bar to its UP position.
2) Press switch 1 for approximately three seconds to display the information screen.
2: Ver display For the details, refer to the Engineer’s Manual.
3: Sewing common data
4: Function setting Refer to 6-16. Function setting procedure.
5: Sewing management information
6: Communication mode
7: Hook adjusting mode Refer to 8-6. Hook adjusting mode.
8: Smart media format For the details, refer to the Engineer’s Manual.
1
■Information screen (Maintenance personnel level)]
2 3 4 5 6 7
8
To Next Page
Loading...
Need help?
General
