Sewing Test
Sewing Test
After threading make a sewing test on a double layer of fabric to check
the stitch formation and the thread tension.
Cover stitch sewing test
・
Plug the machine in and switch it on (power switch to “I”).
・
Set the tensions to 3-5.
・
Set the stitch length to 3.
・
Set the differential feed to N.
・
Raise the presser foot and place the fabric under foot and needles (A).
・
Lower the presser foot.
・
Turn the handwheel counterclockwise for the rst stitch.
・
Sew
・
When sewing is completed (still inside the work), turn the handwheel
counterclockwise to bring the needles into their lowest position (B).
Then turn the handwheel clockwise to raise the needles to their highest
position. This releases the needle threads from the looper and stitching
can unravel easily.
・
Raise the presser foot.
・
Remove the work carefully towards the left.
・
Cut the threads over the thread cutter (C).
Chainstitch sewing test
・
Plug the machine in and switch it on (power switch to “I”).
・
Set the tensions to 3-5.
・
Set the stitch length to 2.5.
・
Set the differential feed to N.
・
Raise the presser foot and place the fabric under foot and needle (A).
・
Lower the presser foot.
・
Turn the handwheel counterclockwise for the rst stitch.
・
Sew
If seam ends in the fabric:
When sewing is completed, turn the handwheel counterclockwise to
bring the needles into their lowest position (D).
Then turn the handwheel clockwise to raise the needles to their highest
position. This releases the needle thread from the looper.
・
Raise the presser foot.
・
Remove the work carefully towards the left.
・
Cut the threads over the thread cutter (C).
A
B
C
D
20
To Next Page
Loading...
Need help?
General
