– 7 –
ENGLISH
2
3
4
B
A
7. Adjusting the machine head
WARNING :
Be sure to perform the angle adjustment of the machine head by the operation below before using
the machine head.
1) Simultaneously pressing switch
2
and
switch
3
, turn ON the power switch.
2)
is displayed (
A
) in the indicator and the
mode is changed over to the adjustment mode.
3) Turn the handwheel by hand and angle
B
is dis
-
played in the indicator when the reference signal
has been detected. (The value is a reference
value.)
4) In this state, align the white dot
5
of the hand
-
wheel with the concave
6
of the pulley cover as
shown in the gure.
5) Press
switch
4
to finish the adjustment
work. (The value is a reference value.)
6
5
To Next Page
Loading...
Need help?
General
