JUKI SC-810 User Manual

– 19 –
ENGLISH
5. Detailed explanation of selection of functions
1
Selection of the soft-start function (Function setting No. 1)
The needle thread may fail to interlace with the bobbin thread at the start of sewing when the stitching pitch
(stitch length) is small or a thick needle is used. To solve such problem, this function (called “soft-start”) is
used to limit the sewing speed, thereby assuring successful formation of the starting stitches.
0 : The function is not selected.
1 to 9 : The number of stitches to be sewn under the soft-start mode.
The sewing speed limited by the soft-start function can be changed. (Function setting No. 37)
Data setting range
150 to MAX. rpm <50 rpm>
2
Flicker reducing function (Function setting No. 5)
The function reduces ickering of the hand lamp at the start of sewing. The higher the set value increases,
the more effective the function will work.
Setting range : 0 to 3
0 : Flicker reducing function does not work.
to
3 : Flickering is effectively reduced.
(Caution) Themoreeffectivetheickerreducingfunctionworks(themorethesetvalueismade),thelower
the start-up speed of the sewing machine will become.
3
Bobbin thread counting function (Function setting No. 6)
When the control panel (CP-160/CP-170) is used, the function subtracts from the predetermined value and
indicates the used amount of bobbin thread.
For the details, refer to the instruction manual for the control panel.
(Caution) When setting is "0", LED display on the operation panel goes out, and the bobbin thread count
function becomes invalid.
For the details, refer to "Caution" of "
7
Sewing counting function (Function setting No. 14)"
4
Thread trimming prohibiting function (Function setting No. 9)
This function turns OFF thread trimming solenoid output and wiper solenoid output when thread trimming is
actuated. [If the control panel (CP-160/CP-170) is used with the sewing machine, this function will work in
accordance with the function setting on the control panel.]
By this function, separate sewing material can be spliced and sewn without trimming thread.
0 : off Thread trimming is operative. (thread can be trimmed).
1 : on Thread trimming is inoperative. (thread can not be trimmed).
5
Setting of the needle bar stop position when the sewing machine stops (Function setting No. 10)
The position of the needle bar when the pedal is in its neutral position is specied.
0 : Down The needle bar stops in the lowest position of its stroke.
1 : Up The needle bar stops in the highest position of its stroke.
When connecting CP-160/CP-170, holding pressing needle up/down compensating switch
1
, turn ON the
power and the stop position can be changed.
1
0
0
3 7
8 0 0
5
0
1 0
0
9
0
n P
L o
n P
U P
(Caution) If the stop position of the needle bar is set to the highest
position, the thread trimming action will be taken after the
needle bar comes down once to the lowest position.
Down stop position
Up stop position
1

JUKI SC-810 Specifications

General

Brand	JUKI
Model	SC-810
Category	Sewing Machine
Language	English