EN
Upper feed presser foot
CAUTION:
Turn OFF the power switch when replacing the presser foot.
1
Turn off power and remove the presser
foot.
2
Install the upper feed presser foot.
Fit forked portion of the actuating lever to the
needle clamp, insert the installing portion into the
presser bar, and securely tighten the screw in the
presser foot.
Once presser foot is installed, rotate handwheel
by hand in sewing direction to conrm fork position
correctly then turn power on.
* Turn the presser foot pressure regulator to set
the presser foot pressure to “low”.
(Set the pressure to “lowest” when sewing the vel-
vet material.)
Use the sewing machine at medium speed.
Generally, this presser foot is used for hard-to-feed or for difcult-to-feed materials such as velvet, jersey, vinyl,
cloth articial leather, leather, etc. This smoothly feeds the material and prevents the material from slipping.
Presser foot
Screw in the
presser foot
Needle clamp
screw
Actuating lever
Screw in the
presser foot
Turn to
to
decrease the
presser foot
pressure.
Increase Decrease
25
To Next Page
Loading...
Need help?
General
