EN
●
Front open type
This type is suited for free-motion
quilting. The needle entry point is
easily observed since the front sec-
tion is open.
Quilting foot
CAUTION:
Turn OFF the power switch when replacing the presser foot.
This quilting foot is convenient for free motion quilting, quilting along with the pattern, free-hand embroidery, etc.
* Do not run the sewing machine idle when the quilting foot is kept at its upper position.
1
Turn off power. Install the quilting foot. Put
the plate on the needle clamp screw, insert
the installing portion into the presser bar, and
securely tighten the screw in the presser foot.
2
Position Feed Dog in lower position.
3
Position stitch length adjusting dial ”0”. Rotate
presser foot pressure regulator until blue bar
in pressure indication window is at top.
4
Lower the foot and start sewing.
1/5 inch (5.0 mm)
1/8 inch (3.2 mm)
●
1/5 inch = 5.0 mm type
This type is suited for free-motion
quilting in general.
1/5 inch (5.0 mm)
1/8 inch (3.2 mm)
1/4 inch (6.5 mm)
1/8 inch (3.2 mm)
●
1/4 inch = 6.5 mm type
This type is suited as a guide for
sewing stitches at regular intervals.
Plate
Screw in the presser foot
Needle clamp screw
Presser
bar
29
To Next Page
Loading...
Need help?
General
