JUKI TL Series User Manual

–
12
–
15. Drop-feed knob
❸
E-ring
❺
Wire installing plate asm.
❷
DF adjusting arm spring
❻
DF adjusting arm asm.
❶
Drop-feed knob
14. Hand lifter lever
❶
Hand lifter lever
❷
Hand lifter lever shaft
❸
M4 screw
❹
Drop feed knob shaft setscrew
❹
Hand lifter lever shaft set screw
ⓐ
Flat part
Disassembly Assembly Point
○ Set
❶
drop-feed knob to "NOT
FEED", remove
❹
drop feed
knob shaft setscrew, and remove
❸
E-ring of drop feed knob.
○ Remove
❷
DF adjusting arm
spring while removing
❻
DF ad-
justing arm asm..
○ Pass
❶
drop feed knob through
❺
wire installing plate.
○ Assemble
❷
DF adjusting arm spring
while assembling
❻
DF adjusting
arm asm..
○ Place
❸
E-ring to
❶
drop feed knob.
○ Assemble drop feed knob shaft with
❹
setscrew.
○ It is easy to remove
❷
spring
when
❶
drop-feed knob is
set to “NOT FEED” side.
Disassembly Assembly Point
○ Loosen hand lifter lever shaft setscrew
❹
.
○ Insert M4 screw
❸
into tapped hole in
hand lifter lever shaft
❷
by 3 to 4 screw
threads.
○ Hold screw head and draw out the screw.
○ At the same time, also draw out hand lift-
er lever shaft.
○ Remove hand lifter lever
❶
.
○ Put hand lifter lever shaft
❷
into
the hole in the frame.
○ Secure hand lifter lever shaft
❷
by tightening hand lifter lever
shaft setscrew
❹
in such a way
that the tip of setscrew
❹
comes
in contact with the flat part on
hand lifter lever shaft
❷
.
○ End face
ⓐ
of hand lifter
lever shaft
❷
should not
jut out from the frame
surface.

JUKI TL Series Specifications

General

Brand	JUKI
Model	TL Series
Category	Sewing Machine
Language	English