JUKI TL Series User Manual

–
4
–
1. Arm cover asm.
3. Face plate asm.
Preparation
○ Remove arm cover.
2. Belt cover and motor cover
Outer Components
❶
Arm cover setscrew
SM5042005SN
❸
Arm cover
❻
Convex of presser spring
regulator knob
❺
Slit of presser regulating screw
❸
Face plate asm.
❶
Lamp connector
❺
Face cover
❷
Face plate asm. setscrew
SL5040631SE
❻
Hand lifter lever spring
❹
Indicating needle of
presser spring regulator
❷
Motor cover setscrew
SM5041255SN
❶
Belt cover setscrew
SM5041255SN
❹
MAIN circuit
board case cover
Disassembly Assembly Point
○ Remove two
❶
setscrews.
○ Disconnect and remove
❷
con-
nector.
○ Insert
❷
connector.
○ Align
❻
convex with
❺
slit and
tighten the setscrew.
○ There should be no torsion or dis-
torsion in presser spring regulator.
○ Align precisely slit portion with con-
vex portion.
○ Do not press each lead wire.
Disassembly Assembly Point
○ Remove four
❶
setscrews and
remove belt cover.
○ Remove three
❷
setscrews and
remove motor cover.
○ Attach belt cover and tighten
❶
setscrews.
○ Attach motor cover and tighten
❷
setscrews.
○ There should be no difference
in level between belt cover and
front face of frame.
○ Make motor cover come closely
contact with belt cover.
Disassembly Assembly Point
○ Disconnect
❶
connector and
❻
remove.
○ Remove
❷
setscrews and re-
move
❸
face plate asm.
(together with face cover).
○ Attach
❸
face plate asm., tighten
it with face plate asm.
❷
set-
screws, and attach
❻
hand lifter
lever spring.
○ Insert
❶
connector.
○ There should be no difference in
level around the cover when face
cover is closed.
○
❺
should not come in contact
with
❹
indicating needle.
❷
Bobbin
winder
connector

JUKI TL Series Specifications

General

Brand	JUKI
Model	TL Series
Category	Sewing Machine
Language	English