To Next Page

To Previous Page

D 3

1001.GB

4 Charging the battery

As default, the truck is to be loaded with a stationary battery charger. The truck wit-

hout wheel-arm lifting device can optionally be supplied with an integrated battery

charger.

For recharging the battery, the truck has to parked in-doors in a sufficiently ventilated

environment.

Charging condition display (refer to chapter E).

4.1 Charging the battery with stationary battery charger

– Park the truck and render it safe (refer to chapter E).

Connection / disconnecting battery connector and socket as well as pressing the ma-

ster switch (2) may only be performed with truck and battery charger being switched

off.

– Expose the battery (refer to section 3).

During the recharging operation the tops of the battery cells must be exposed to en-

sure adequate ventilation. Metal objects must not be placed on the battery. Prior to

starting the recharging operation, check all cable connections and plugged connec-

tions for visible damage.

The safety instructions provided by the battery supplier and battery charger supplier

must be strictly observed.

– Pull battery connector (3) from the plug and socket connection of the truck.

– Remove insulation mat from battery, if necessary.

– Connect the charging cable (4) of the battery recharging station with the battery

connector (3) and switch on the battery charger.

Recharge the battery observing the instructions provided by the battery supplier and

by the battery charger supplier.

D 3