1001.GB
F 8
6 Notes on maintenance
6.1 Preparation of the truck for servicing and maintenance operation
All required safety measures must be taken to prevent any accidents in the course of
the servicing and maintenance operations. The following preparatory operations
must be performed:
– Park the truck and render it safe (refer to chapter E).
– Disconnect the battery connector to prevent accidental or unauthorised truck ope-
ration.
f
When working under raised forks or the raised vehicle, they should be secured so that
the possibility of them dropping, tipping or slipping is excluded. When the vehicle is
raised, the instructions in the Chapter ”Transport and commissioning” must also be
observed.
The vehicle should be secured against rolling away before doing any work on the ser-
vice / parking brakes.
6.2 Opening the front cover
Truck equipped with hinged driver standing platform:
– Fold down the stand-on platform (1) and fold out safety frame (2).
General:
– Unscrew screws (3) with a hex. socket wrench (socket width 8) (Key (4) in battery
compartment).
– Lift front hood (3), remove it from the truck and keep it in a safe place.
– Installation is in the reverse sequence of operations.
f
Drive only with closed and properly locked hoods!
1
2
3
4
1001.GB
F 8
6 Notes on maintenance
6.1 Preparation of the truck for servicing and maintenance operation
All required safety measures must be taken to prevent any accidents in the course of
the servicing and maintenance operations. The following preparatory operations
must be performed:
– Park the truck and render it safe (refer to chapter E).
– Disconnect the battery connector to prevent accidental or unauthorised truck ope-
ration.
f
When working under raised forks or the raised vehicle, they should be secured so that
the possibility of them dropping, tipping or slipping is excluded. When the vehicle is
raised, the instructions in the Chapter ”Transport and commissioning” must also be
observed.
The vehicle should be secured against rolling away before doing any work on the ser-
vice / parking brakes.
6.2 Opening the front cover
Truck equipped with hinged driver standing platform:
– Fold down the stand-on platform (1) and fold out safety frame (2).
General:
– Unscrew screws (3) with a hex. socket wrench (socket width 8) (Key (4) in battery
compartment).
– Lift front hood (3), remove it from the truck and keep it in a safe place.
– Installation is in the reverse sequence of operations.
f
Drive only with closed and properly locked hoods!
1
2
3
4
To Next Page
Loading...
Need help?
General
