Juniper EX Series Quick Start Guide

(Optional) Reconfigure Switch Priority
You can override the default RPS switch priority by configuring RPS priority on the switches. For directions on changing
switch priority, see the redundant-power-system priority command in the Complete Guide for the EX Series Redundant
Power System.
(Optional) Configure Power to Support Only Non-PoE Switches
If you don’t need to support PoE, your RPS can provide power to up to six connected switches simultaneously (two per
power supply). For directions on changing the power setting, see the request-redundant-power-system multi-backup
command in the Complete Guide for the EX Series Redundant Power System.
Step 3: Keep Going
IN THIS SECTION
Safety Warnings Summary | 6
Power Cable Warning (Japanese) | 7
Contacting Juniper Networks | 7
See the complete RPS documentation at https://www.juniper.net/documentation/.
Safety Warnings Summary
This is a summary of safety warnings. For a complete list of warnings, including translations, see the Complete Guide for
the Redundant Power System at https://www.juniper.net/documentation/.
•
Permit only trained and qualified personnel to install or replace RPS components.
•
Perform only the procedures described in this guide and the EX Series documentation. Other services must be performed
only by authorized service personnel.
•
Before installing the RPS, read the planning instructions in the documentation to make sure that the site meets power,
environmental, and clearance requirements.
•
Before connecting a RPS to a power source, read the installation instructions in the documentation.
6

Juniper EX Series Specifications

General

Brand	Juniper
Model	EX Series
Category	Switch
Language	English