The J-Web login page appears.
6. Log in using the root authentication password.
The J-Web Setup application displays.
Plug and Play
The SRX550 HM already has factory-default settings configured to make it a plug and play device. So all you have to do
to get the SRX550 HM up and running is connect it to your LAN and WAN networks.
1. Connect the WAN network to port 0/0 to obtain a dynamic IP address.
2. Connect the LAN network to any of the ports from 0/1 through 0/5.
3. Check to see if the SRX550 HM is connected to the Internet. Go to http://www.juniper.net. If the page does not load,
check the Internet connection.
After you complete these steps, you can start using the SRX550 HM on your network right away. You can go back and
customize settings at anytime. The J-Web Setup wizard is always available to you.
11
To Next Page
Loading...
Need help?
General
