5
Stop backup recording.
0
Select [STBY] in [System] B [Record Set] B
[
Slot Mode
]
B [Backup Rec] and press the
Set button (R).
(A P126
[ Slot Mode ] )
0
You can also press the user button that is
assigned with “Backup Trig”.
(A P105 [User Switch Set Item] )
0
Recording to slot B stops, and the card slot
mark of
slot
B turns white (unselected state).
0
The characters “BACKUP” changes back to
white.
0
The status indicator of slot B lights up in
green.
.
1/100
F1. 6
18
dB
AE+6
ND 1 /1 6
12 :34 :56
Jan 24,2015
00:00: 00.00
4030 20 10 0
5 . 6 f t
P 15000K
100min
50min
100min
50min
White
Memo :
0
During backup recording, if the space of one
card runs out, recording stops only for the card
that is full.
0
When recording to both slots is stopped,
recording in the
Regen mode will be enabled for
the card slot in which recording started.
0
When recording is started in the other slot while
recording to one slot, the clip being recorded is
split and simultaneous recording to the other
card starts.
0
When recording is stopped for either slot A or B
while recording to both slots, the clip on the slot
which is still recording is split.
0
Although the clips are separated during
recording the clips can be seamlessly joined by
arranging them on the timeline of the editing
software since they are recorded seamlessly.
0
Clip Cutter Trig cannot be performed during
backup recording.
(A P87 [Splitting the Clips Freely (Clip Cutter
Trig)] )
0
When [Slot Mode] is set to “Backup”, [Rec
Mode] can only be set to
“Normal”.
(A P125 [ Rec Mode ] )
Special Recording
Besides the normal recording mode, four special
recording methods are available in this camera
recorder. They are Pre Rec, Clip Continuous,
Frame Rec and Interval Rec.
Select a mode from
[System]
B [Record Set] B
[Rec Mode].
(A P125 [ Rec Mode ] )
Memo :
0
Special recording cannot be selected when
[System]
B
[Record Set]
B
[Record Format]
B
[System] is set to “HD+Web” or “High-Speed”.
Pre Rec
0
By setting the
number of seconds in the [Pre Rec
Time], you can start recording video and audio
before actual recording starts based on the [Pre
Rec Time] setting.
0
When starting actual
recording while the camera
recorder is in Recording Standby (STBYP)
mode, you can start recording a few seconds
earlier based on the [Pre Rec Time] setting.
0
Using Pre Rec allows you to record a complete
event without missing the initial scenes even if
you start the recording late.
Memo :
0
Pre Rec Time
can be set in [System] B [Record
Set] B [Rec Mode] B [Pre Rec Time].
The following values can be selected depending
on the setting of [System] B [Record Set] B
[Record Format] B [System].
0
When [System
]
is set to “4K”:
Fixed at “5sec”
0
When [System] is set to “HD” or “SD”:
“5sec”, “10sec” or “15sec”
(A
P125 [ Pre Rec Time ] )
82
Backup Rec
Shooting
To Next Page
Loading...
Need help?
General
