JVC GY-HM250UG User Manual

Frame Rec
In normal recording, when the recording stops, the
image and accompanying
data from the start till the
end of the recording are recorded as one “clip” on
the SD card.
In this mode, recording starts with every press of
the [REC] button, and only the specified number of
frames is recorded.
The recording can be written to the media as a
single clip until it is stopped.
Memo :
0
Audio will not be recorded.
0
Until a specified amount of recordings is
accumulated, the file cannot be written to the
media.
0
If the specified amount is not reached when
recording is stopped, normal recording is
performed and frames are added to the ending
of the clip
until the amount is reached. (Padding)
0
After the specified number of frames is recorded
and written to the media, recording will be
performed until the same number is
accumulated again.
.
Specific amount of data
Actual clips recorded to the media
Records number of frames specified in [Rec Frames]
(Padding data)
Normal recording
PausePausePause
Recording resumes Recording resumes
Press [REC]Press [REC]
(Frame Rec stops)(Frame Rec starts)
Press and hold [REC]Press [REC]
1
Set [Rec Mode] to “Frame Rec”.
0
Set [System] B [Record Set] B [Rec Mode]
to “Frame Rec”.
(
A P125 [ Rec Mode ] )
0
The display changes (“STBY
”
B “STBYM”).
2
Set the number of frames to record in [Rec
Frames].
0
To configure the setting, go to [System]
B
[Record Set] B [Rec Mode] B [Rec Frames].
(A P
125 [ Rec Frames ] )
3
Start recording.
0
Press the [REC] button to record only the
number of frames specified in [Rec Frames]
and pause.
0
The display changes (
“STBYM
”
B “RRECM”
B “STBYM” (yellow text)).
0
The card slot status indicator lights up in
green.
4
Repeat Frame Rec.
0
Press the
[REC]
button again to record only
the number of frames specified in [Rec
Frames] and pause.
0
The display changes (“STBYM” B “RRECM”
B “STBYM” (yellow text)).
0
Frame Rec continues until the recording is
stopped (step 5).
5
Press and hold the [REC] button.
0
The card slot status indicator lights up in
green.
Caution :
0
Do not remove the SD card during recording
(“RRECM”, red text) or recording pause
(“STBYM”, yellow text).
0
To remove the
SD card during Frame Rec, press
the [CANCEL/STOP] button, check that
“STBYM” (white text) is displayed and the card
slot status indicator lights up in green before you
remove the card.
0
When [TC/UB]
B [TC Generator] is set to “Free
Run”, the time code will be recorded in “Rec
Run”.
0
Audio cannot be recorded. The audio level
meter is grayed out.
(A P140 [Audio Level Meter] )
Special Recording
85
Shooting

JVC GY-HM250UG Specifications

General

Brand	JVC
Model	GY-HM250UG
Category	Camcorder
Language	English