12
ENGLISH
Storing stations in memory
You can use one of the following two methods to
store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-
station Sequential Memory)
• Manual preset of both FM and AM (MW/LW)
stations
FM station automatic preset: SSM
You can preset 6 local FM stations in each FM
band (FM1, FM2 and FM3).
1
Select the FM band (FM1 – 3) you want
to store FM stations into.
1 Press SOURCE
repeatedly to select
FM.
2 If necessary, press B
(band) repeatedly to
select the FM band.
Each time you press
the button, the FM
band changes as
follows:
2
Press and hold both buttons for more
than 2 seconds.
(FM 1) (FM 2) (FM 3)
F 1 F 2 F 3
Local FM stations with the strongest signals are
searched and stored automatically in the band
number you have selected (FM1, FM2 or FM3).
These stations are preset in the number buttons
— No.1 (lowest frequency) to No.6 (highest
frequency).
When automatic preset is over, the station stored
in number button 1 will be automatically tuned in.
Manual preset
You can preset up to 6 stations in each band
(FM1, FM2, FM3 and AM (MW/LW)) manually.
Ex.: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band.
1
Select the band (FM1 – 3, AM) you
want to store stations into (in this
example, FM1).
1 Press SOURCE
repeatedly to select
FM as the source.
2 If necessary, press B
(band) repeatedly to
select FM1. Each time
you press the button,
the FM band changes
as follows:
(FM 1) (FM 2) (FM 3)
F 1 F 2 F 3
“SSM” appears, then disappears when
automatic preset is over.
EN10_13SH909_707R[E]f.pm5 1/23/02, 11:23 AM12
To Next Page
Loading...
Need help?
General
