ENGLISH
51
Storing DAB services in
memory
You can preset up to 6 DAB services in each DAB
band (DAB 1, DAB 2 and DAB 3) manually.
1
Select the DAB tuner.
When you select a source,
the power automatically
comes on.
Each time you press the
button, the source changes
as follows:
* Without connecting the DAB tuner or CD
changer, you cannot select it as the source to
play.
** If a disc is not in the loading slot, you cannot
select CD as the source to play.
*** When “LINE IN” or “AUX IN” is set to
“OFF,” you cannot select it as the source to
play. (See page 39).
2
Select the DAB band (DAB 1, DAB 2
or DAB 3) you want.
Each time you press the
button, the DAB band
changes as follows:
3
Tune in to an ensemble you want.
(DAB 1)
(DAB 2)
(DAB 3)
D1
D2
D3
4
Select a service of the ensemble
you want.
1 Press M (mode).
2 Press and hold
¢ or 4
to select a service
you want.
5
Press and hold the number button
(in this example, 1) you want to
store the selected service into for
more than 2 seconds.
6
Repeat the above procedure to
store other DAB services into other
preset numbers.
Notes:
• A previously preset DAB service is erased when a
new DAB service is stored in the same preset
number.
• Preset DAB services are erased when the power
supply to the memory circuit is interrupted (for
example, during battery replacement). If this
occurs, preset the DAB services again.
AM TUNER (AM)
FM TUNER (FM)
DAB TUNER (DAB)*
LINE INPUT (LINE)***
CD CHANGER (CDCH)*
CD**
AUX INPUT (AUX)***
Back to the beginning
“1” lights up for a while.
EN49_52SH909_707R[E]f.pm5 1/23/02, 11:39 AM51
To Next Page
Loading...
Need help?
General
