4
ENGLISH
CAUTION on Volume Setting
CDs produce very little noise compared with other sources. If the volume level is adjusted for the tuner, for
example, the speakers may be damaged by the sudden increase in the output level. Therefore, lower the
volume before playing a disc and adjust it as required during playback.
Note:
For security reasons, a numbered ID card is provided with this unit, and the same ID number is imprinted on
the unit’s chassis. Keep the card in a safe place, as it will help the authorities to identify your unit if stolen.
How to change the display patterns:
This unit is equipped with two display indication patterns – with or without the source symbol
animation.
To change the display patterns, press M (mode), then press D (display) within 5 seconds.
Each time you press D (display), the display patterns change as follows:
Note:
The display illustrations used in this manual are with the source symbol animations and with “CLOCK” set to
“ON.” (See page 38.)
How to use the M (mode) button:
If you press M (mode), the unit goes into functions mode and the number, 4/¢ and
D (display) buttons work as different function buttons.
To use these buttons for their original functions (ex. as the number buttons) again after pressing
M (mode), wait for 5 seconds without pressing any of these buttons until the functions mode is cleared.
• Pressing M (mode) again also clears the functions mode.
During functions mode:
Time countdown indicator lights up
Ex.: While receiving an FM station...
(Initial setting)
EN02_05SH909_707R[E]f.pm5 1/23/02, 11:18 AM4
To Next Page
Loading...
Need help?
General
