9
Auto setup
Your television has an Automatic Tuning
System which makes tuning in your television
easy. This Automatic tuning System scans
the entire reception range in your area and
automatically stores all available analogue
channels of suitable signal strength in the
correct order.
Preparation:
Press (Power) on the unit or on the remote.
1
Auto Installation menu will appear.
Press ◀ or ▶ to select desired language.
Then press ▼
.
Please select an OSD Language
OSD Language
Auto Sleep 4 H
English
Please press ENTER button to
2
If you cancel Auto Sleep (see page 14),
press ◀ or ▶ to select Off.
OSD Language
Auto Sleep 4 H
English
Please select an OSD Language
Please press ENTER button to
3
TV will search for TV-channels. Connect your
antenna now.
Continue with ENTER to start auto tuning.
The tuning’s progress will be displayed in
percent for confirmation.
Channel Tuning
TV : 0 Programme(s)
4 %... 79.50 MHz (TV)
Menu
Note:
Please be patient - the Auto Tuning process
can take several minutes to complete.
•
4
When the display reads 100%, normal TV-screen will
appear.
Note:
To cancel the auto tuning, press RETURN,
then press ◀ to select Yes during the process.
THE AUTOMATIC TUNING PROCESS WILL
ONLY START BY ITSELF THE FIRST TIME YOU
SWITCH THE SET ON. HOWEVER YOU CAN
RESTART THIS PROCESS VIA THE MENU
SYSTEM (see page 14).
If you could not set up a correct language in this auto
setup process, you will be able to make your preferred
language selection as illustrated in page 10 (On-screen
Language Selection).
•
•
Quick guide for Menu operation
Call Menu and for example: Select “Auto
Tuning”.
1
Press INPUT SELECT. Select TV, then press
ENTER. Press MENU.
2
Press ◀ or ▶ to select “CHANNEL”,
then press ENTER.
Auto Tuning
CHANNEL
CHANNEL
ATV Manual Tuning
Programme Edit
3
Press or to select “Auto Tuning”, then press ▶ or ENTER.
Auto Tuning
CHANNEL
CHANNEL
ATV Manual Tuning
Programme Edit
... on the following pages the MENU can be called in
the same way as here.
4
Press RETURN to exit the menu.
Note:
The Menu screen disappears automatically after a
defined period of time with “OSD Timer”. (see page 14)
•
Selecting the input source
Press INPUT SELECT to view a signal from
another device connected to your TV, such as a
VCR or DVD player. You can select each input
source depending on which input jacks you used to
connect your devices.
To select the video input source, press
/ , then
press ENTER.
3IZ0101C_EN.indd 93IZ0101C_EN.indd 9 10/21/11 12:05:35 PM10/21/11 12:05:35 PM
To Next Page
Loading...
Need help?
General
