18
Operation
Selecting an input source
The projector can be connected to multiple equipment at the same time. However, it only
displays one full screen at a time. When starting up, the projector automatically searches for the
available signals.
If you want the projector to always automatically search for the signals:
• Go to the SYSTEM menu, and then enable Auto Input Search. (see "Auto Input Search" on
page 26)
To select the video source:
1. Press INPUT to display the source selection bar.
2. Press / until your desired signal is selected and press OK.
Once detected, the selected source information displays on the screen for seconds. If there
are multiple pieces of equipment connected to the projector, repeat steps 1-2 to search for
another signal.
Refer to "Projector specifications" for the native display resolution of this projector. For best display
picture results, you should select and use an input signal which outputs at this resolution. Any other
resolutions will be scaled by the projector depending upon the Aspect Ratio setting, which may cause
some image distortion or loss of picture clarity. See "Aspect Ratio" for details.
Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 2 adjuster feet. These
adjusters change the image height and projection angle.
Screw the feet in or out as appropriate to aim and level the
projection angle.
If the screen and the projector are not perpendicular to each
other, the projected image becomes vertical trapezoidal. To
correct this, see "Correcting keystone" for details.
Do not look into the lens while the
light source is on. The strong light
from the light source may cause
damage to your eyes.
To Next Page
Loading...
Need help?
General
