29
Menu Functions
POWER MANAGEMENT menu
Warping
This function aims at correcting the geometric distortion of the projector’s
images when they are projected onto an uneven surface such as a cylinder, a
spherical shape, etc.
• Enable
When this function is enabled, the following functions will not be available:
Keystone, Corner Adj..
• Control Method
Allows you to select a preferred control method for warping adjustment.
• Warping Adj.
This function is available when On is selected in the Warping > Enable menu
and OSD is selected in the Warping > Control Method menu.
1. Use / / / to move the cursor to the point you wish to adjust.
2. Press OK to enter adjustment mode.
3. Use / / / to shift the point by x and y coordinates.
4. Press MENU to exit adjustment mode.
5. Repeat step 1 to 4 to ajdust another point until you are satisfied with the
projected image.
6. Press MENU to exit the function.
• Reset
Returns settings in the Warping menu to the factory preset values.
Zoom
Zoom your lens between 0.8X ~ 2.0X. The default is 1.0 X.
Digital Zoom
Digitally zoom the vertical/horizontal focus from -50 to 50.
The function is not available when Zoom is 1.0X or higher.
OverScan
Conceals the poor picture quality in the four edges.
The greater the value, the more portion of the picture is concealed while the
screen remains filled and geometrically accurate. Setting 0 means the picture
is 100% displayed.
Submenu Functions and Descriptions
Auto Power On
• Signal
When Signal is set to HDMI, projector will auto power up from standby mode
when HDMI signal is plugged into projector.
• Direct Power On
Allows the projector to turn on automatically once the power is fed through the
power cord.
Submenu Functions and Descriptions
To Next Page
Loading...
Need help?
General
