10
Basic Operations
1
Turn On the Power
Press (or AUDIO button on the remote
control).
The STANDBY lamp goes off. The current
source indicator lights green. The name of the
current source (or station frequency) appears on
the display.
To turn off the power (into standby)
Press (or AUDIO ) again.
The STANDBY lamp lights up.
A small amount of power is consumed in standby
mode. To turn the power off completely, unplug
the AC power cord.
2
Select the Source to Play
Press one of the source selecting buttons.
DVD :Select the DVD player.
STB : Select STB.
VCR :Select the VCR.
TV : Select the TV tuner.
TAPE : Select the cassette recorder.
FM/AM : Select an FM or AM broadcast.
The selected source indicator lights green.
DVD STB VCR TV TAPE
FM/AM
TV DIRECT
DVD
MEMORY
CONTROL
ADJUST
SETTING
STANDBY
DIGITAL
DIGITAL
SURROUND
INPUT
ANALOG/DIGITAL
INPUT ATT
MASTER VOLUME
SURROUND
ON/OFF
DSP
MODE
ANALOG
PRO LOGIC
SUBWFR LFE
SLEEP RDS EON TA STTUNEDINFOHEWS MUTING
MH
Z
KHZ
VOL
AUTO
DGTL AUTO
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
123
RX-E100R
DVD STB VCR TV TAPE FM/AM
HOME CINEMA CONTROL CENTER
STANDBY/ON
This manual mainly explains operations using the buttons and controls on the front panel. You can also use the buttons on the remote
control if they have the similar names (or marks) as those on the front panel.
If operations using the remote control are different from those using the front panel, they are then explained.
• You can also see “Mastering Remote Operations” on page 40.
Display Source indicators
MASTER VOLUME
3
Adjust the Volume
To increase the volume, press and hold
MASTER VOLUME
(or VOLUME + on the
remote control).
To decrease the volume, press and hold
MASTER VOLUME
(or VOLUME – on the
remote control).
CAUTION:
Always set the volume to the minimum before starting any source. If
the volume is set at its high level, the sudden blast of sound energy
can permanently damage your hearing and/or ruin your speakers.
Notes:
• The volume level can be adjusted within the range of “0” (minimum)
to “70” (maximum).
• Each time you press the button, the volume level changes by 2
steps from “0” (minimum) to “14” and by 1 step from “14” to “70”
(maximum).
Note:
When you have connected some digital source components using the
digital terminals (see page 7), see “Basic Settings” on pages 13, 14,
and 15 to finish the digital input terminal setting and digital input mode
setting correctly before use.
STANDBY
STANDBY/ON
STANDBY lamp TV DIRECT
VOL
DGTL AUTO
LR
LPCM
Current volume level is shown here
Current source name appears
STANDBY
STANDBY/ON
DVD STB VCR TV TAPE
FM/AM
DVD
EN10-19.RX-E100RSL[B]_f 01.3.8, 2:49 PM10
To Next Page
Loading...
Need help?
General
