To Next Page

To Previous Page

(No.MB616<Rev.002>)1-31

3.2.14 Removing the sensor board and SV resistor

(See Fig.33)

• Remove the tray assemblies, side (L), side (R) assembly and

lifter assembly.

(1) Remove the solders from the soldered sections aj on the

sensor board and remove the wires.

(2) Remove the two screws Q and take out the sensor board

with the SV resistor.

Reference:

• Remove the soldered section ap on the sensor board as re-

quired.

• When reassembling, pass the wires through the slot ak of

the sensor board as before.

Note:

When reattaching the SV. resister, fit the projection am on the

bottom of the SV. resister into slot an of the sensor slider.

Fig.33

Sensor board

SV resistor

Slider

JVC SP-DXU10C User Manual

Questions and Answers: