EasyManuals Logo
Home>KEB>Controller>COMBIVERT F6

KEB COMBIVERT F6 Instruction Manual

KEB COMBIVERT F6
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
GB - 11
Technical Data
2. Technical Data
2.1 Operating conditions
Standard Standard/
class
Instructions
Denitionacc.
EN 61800-2 Inverter product standard: ratedspecications
EN 61800-5-1 Inverter product standard: general safety
Site altitude
max. 2000 m above sea level
With site altitudes over 1000 m a derating of 1 % per
100 m must be taken into consideration.
Ambient conditions during operation
Climate
Temperature
EN 60721-3-3
3K3
extended to -10…45 °C (use frost protection for water
cooling systems and temperatures below zero)
With temperature over 45°C to max. 55°C a derating of
5 % per 1 K must be taken into consideration.
Humidity 3K3 5…85 % (without condensation)
Mechanical Vibration 3M1
Contamination
Gas 3C2
Solids 3S2
Ambient conditions during transport
Climate
Temperature
EN 60721-3-2
2K3 Drain heat sink completely
Humidity 2K3 (without condensation)
Mechanical
Vibration 2M1
Surge 2M1 max. 100 m/s²; 11 ms
Contamination
Gas 2C2
Solids 2S2
Ambient conditions for the storage
Climate
Temperature
EN 60721-3-1
1K4 Drain heat sink completely
Humidity 1K3 (without condensation)
Mechanical
Vibration 1M1
Surge 1M1 max. 100 m/s²; 11 ms
Contamination
Gas 1C2
Solids 1S2
Type of protection EN 60529 IP20
Environment IEC 664-1 Pollution degree 2
Denitionacc. EN 61800-3 Inverter product standard: EMC
EMC emitted interference
Cable-based interferences C3
1)2)
Earlier limit value A (B optional) according to EN55011
Radiated interferences C3
2)
Earlier limit value according to EN55011
Interference immunity
Static discharges EN 61000-4-2 8 kV AD (air discharge) and CD (contact discharge)
Burst - Ports for process meas-
urement control lines and signal
interfaces
EN 61000-4-4 2 kV
Burst - power interfaces EN 61000-4-4 4 kV
Surge - power interfaces EN 61000-4-5 1 / 2 kV Phase-phase / phase-ground
Electromagneticelds EN 61000-4-3 10 V/m
Cable-fed disturbances, induced
byhighfrequencyelds
EN 61000-4-6 10 V 0.15-80 MHz
MM
Voltage variation /
voltage drop
EN 61000-2-1 3
+10 % -15 %
90 %
Voltage unsymmetries /
Frequency changes
EN 61000-2-4 3
3 %
2 %
1)
This product can cause high frequency disturbances in residential areas (category c1) which require noise suppression measures.
2) Thespeciedvalueisonlymeetinconnectionwithacorrespondinglter.

Table of Contents

Other manuals for KEB COMBIVERT F6

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KEB COMBIVERT F6 and is the answer not in the manual?

KEB COMBIVERT F6 Specifications

General IconGeneral
BrandKEB
ModelCOMBIVERT F6
CategoryController
LanguageEnglish

Related product manuals