To Next Page

To Previous Page

Calibration Command Reference

3-1

3.1 Introduction

This section contains detailed information on the various

Model 2001 IEEE-488 bus calibration commands. Section 2

of this manual covers detailed calibration procedures, and

Appendix B lists several calibration programs. For informa-

tion on additional commands to control other instrument

functions, refer to the Model 2001 Operator’s Manual.

Information in this section includes:

3.2 Command summary: Summarizes all commands nec-

essary to perform comprehensive, AC, and low-level

calibration.

3.3 CALibration:PROTected subsystem: Gives detailed

explanations of the various commands used for both

comprehensive and low-level calibration.

3.4 CALibration:UNPRotected subsystem: Discusses the

:ACC command, which is used to perform AC user cal-

ibration over the bus.

3.5 Bus error reporting: Summarizes bus calibration er-

rors, and discusses how to obtain error information.

3.6 Detecting calibration step completion: Covers how to

determine when each calibration step is completed by

using the *OPC and *OPC? commands.

3.2 Command summary

Table 3-1 summarizes Model 2001 calibration commands

along with the paragraph number where a detail description

of each command is located.

Keithley 2001 Calibration Manual

Other manuals for Keithley 2001