2600AS-900-01 Rev. B / September 2008 Return to Section Topics 3-7
Series 2600A System SourceMeter
®
Instruments User’s Manual Section 3: Test Script Processor Interaction
Figure 3-2
Importing a factory script project from the Series 2600A
Step 2: Modifying the test code for the SourceVMeasureI function
As shown in Figure 3-3, the test code for the script functions is contained in the tab for the
“main.tsp” script file. The test code for all of the functions of the KIGeneral factory script are in this
tab. Use the scroll buttons on the right side of the tab to view more code.
Editing example
The following line of code in the “main.tsp” script file applies to the SourceVMeasureI function:
bias = display.prompt("+00.000", " Seconds", "Enter BIAS Voltage.", 0, -40,
40)
A) Click File to display the drop-down file menu
and click Import to open the Import wizard.
B) In the Import Select box, click Existing Project
From Instrument and then click Next.
C) Import Open/Close instrument box With
communications to the Series 2600 open, click
Next.
If communications are not open, use the
drop-down menu to select a resource and
click Open
D) In the Import Project From Instrument box, click
the KIGeneral project, and then cllick Finish.
KIGeneral
KIGeneral
To Next Page
Loading...
Need help?
General
