To Next Page

To Previous Page

2-10 Return to Section Topics 2600S-900-01 Rev. C / January 2008

Section 2: Remote Operation Series 2600 System SourceMeter

Instruments User’s Manual

How do I use other programs?

Reference See the LabVIEW and Visual Basic documentation for details on using those

programs.

Basic source-measure examples using LabVIEW and Visual Basic are shown below. See also

Section 3 for more examples to load and run scripts.

Using LabVIEW

The source-measure example using LabVIEW is shown in Figure 2-7. The test steps are:

1. Reset instrument.

2. Select source voltage function.

3. Set source output voltage.

4. Turn on output.

5. Take current measurement.

6. Reset instrument.

The command sequence for this source-measure example is shown below:

localnode.prompts = 0 -

Disable prompts.

reset() -

Reset Series 2600.

smua.source.func = smua.OUTPUT_DCVOLTS -

Select voltage source function.

smua.source.levelv = volts -

Set voltage source level.

smua.source.output = smua.OUTPUT_ON -

Turn on source output.

print(smua.measurei()) -

Take and return current reading.

reset() - Reset Series 2600.

Keithley 2635 User Manual

Other manuals for Keithley 2635