4 Quick Results Guide
Navigating menus and entering numeric data
Menu navigation
Many operating modes for the Model 6430 are configured using front panel menus.
Throughout this guide, menu navigation will be presented as a sequence of key presses
and menu item selections. For example, the following sequence selects the auto ohms
source mode:
Press CONFIG > press MEAS > select SOURCE > select AUTO
The above sequence is explained as follows:
1. Press the CONFIG key.
2. Press the MEAS key.
3. Select the SOURCE menu item.
4. Select the AUTO ohms source mode.
A menu item is selected by placing the cursor on it and pressing the ENTER key. The
and keys control cursor position.
Numeric data entry (EDIT keys)
Numeric values must be entered for some menu items. Numeric entry is also used to
set source and compliance values. The edit keys for numeric entry include the EDIT
and keys to control cursor position, EDIT and keys to increment or decrement
the digit value, and the number keys.
After a value is keyed in, press ENTER to select it. Note that pressing MENU resets a
displayed number to its minimum value.
Editing source and compliance values
Editing keys
Use the following keys to edit source and compliance values:
• DISPLAY EDIT — Selects the source or compliance display field for editing. A
blinking cursor will appear in the field to be edited. If no key is pressed within a
few seconds, the edit mode will be automatically cancelled.
• EDIT and — Places the display cursor on the display digit to be changed.
• SOURCE or — Increments or decrements the source or compliance value.
Note that pressing either of these keys will automatically enable the source edit mode.
• RANGE or — Selects the source or compliance range.
• NUMERIC KEYS (0-9) — Allow you to directly enter source or compliance values.
• EXIT — Exits the edit mode without waiting for the time-out period.
To Next Page
Loading...
Need help?
General
