Keithley DMM6500 User Manual

In this section:
About this section ................................................................... 10-1
Where can I find updated drivers? .......................................... 10-1
Is there any software to help me get started ........................... 10-2
How do I upgrade the firmware? ............................................ 10-2
Why can't the DMM6500 read my USB flash drive? ............... 10-3
How do I change the command set? ...................................... 10-3
How do I save the present state of the instrument? ............... 10-4
Why did my settings change? ................................................. 10-5
What is the ethernet port number? ......................................... 10-5
About this section
This section helps you find answers to the most common questions encountered with the DMM6500.
Where can I find updated drivers?
For the latest drivers and additional support information, see the Keithley Instruments support
website.
To see what drivers are available for your instrument:
1. Go to tek.com/keithley.
2. Enter the model number of your instrument.
3. Select Software from the filter list.
4. Select Driver from the filter list
If you use the native LabVIEW
TM
or IVI driver, you must configure the DMM6500 to use the SCPI
command set. For information on changing the command set, refer to
How do I change the
command set? (on page 3-18)
Section 10
Troubleshooting FAQs

Keithley DMM6500 Specifications

General

Brand	Keithley
Model	DMM6500
Category	Multimeter
Language	English