Keithley S530 Administrative Guide

Section 5: Instrument specifications and documentation S530 Parametric Test System Administrative Guide
5-4
S530-924-01 Rev. D / September 2017
For systems purchased before September 2015, a 2010 DMM is included instead of the DMM7510.
The 2010 DMM is only connected to the force side of the matrix, however, both the force and sense
connections need to be configured in the icconfig_<QMO>.ini file.
S530 low-current using 4220-PGU pulse generator card
S530 high-voltage system using 4220-PGU pulse generator card
S530 low-current using 4200-SCP2HR scope card
S530 high-voltage system using 4220-SCP2HR scope card
Typical matrix connections
Typical matrix connections for standard instrumentation are shown in the next figure. The first two
slots in each 707B Semiconductor Switch Matrix Mainframe are used for instrument cards. The
remaining four slots in each 707B can be used for pin cards. This will provide Kelvin connections for
48 instrument terminals and up to 60 pin terminals (with two 707B mainframes).
S530 standard 4-wire low-current on 7530-based system
See the connection diagram on the next page.

Keithley S530 Specifications

General

Brand	Keithley
Model	S530
Category	Test Equipment
Language	English