Keithley SourceMeter 2460 User Manual

Model 2460
Interactive SourceMeter® Instrument User's Manual Section 3: U
sing a remote interface
2460-900-01 Rev. A / September 2014 3-13
LAN troubleshooting suggestions
If you are unable to connect to the web interface of the instrument, check the following items:
• Verify that the network cable is in the LAN port on the rear panel of the instrument, not one of the
TSP-Link
®
ports.
• Verify that the network cable is in the correct port on the computer. The LAN port of a laptop may
be disabled when the laptop is in a docking station.
• Verify that the setup procedure used the configuration information for the correct ethernet card.
• Verify that the network card of the computer is enabled.
• Verify that the IP address of the instrument is compatible with the IP address on the computer.
• Verify that the subnet mask address of the instrument is the same as the subnet mask address of
the computer.
• Restart your computer.
• Turn the instrument's power off, and then on. Wait at least 60 seconds for the network
configuration to be completed. Verify that the correct settings are assigned to the instrument:
1. Press the MENU key.
2. Under System, select Communication.
3. Select the LAN tab.
4. Verify the settings.
If the above actions do not correct the problem, contact your system administrator.

Keithley SourceMeter 2460 Specifications

General

Brand	Keithley
Model	SourceMeter 2460
Category	Measuring Instruments
Language	English