MOTOR SAFETYFILTERCHANGING
The motor safety filter must be replaced when dirty. It should be replaced regularly
depending on use conditions. The filter CANNOT be washed as it will lose ils dust trapping
ability.
NOTE: Use replacement motor safety filter STYLECF-1, see part number detail in
REPLACEMENT PARTS (page 6).
_i, WARNING
Electrical Shock Hazard
Turn off and unplug vacuum cleaner from
electrical outlet. Do notoperate the
vacuum cleaner without the motor safety
filter. Be sure the filter isdry and properly
installed to prevent motor Failureand/or
electrical shock.
I. Remove the bag
as outlined in the
BAG CHANGING
section (page 20).
2. Lift the rubber
retainer and pull out
motor safety filter
as shown.
3. Replace the filter,
white side facing
toward dust bag,
by sliding it back
E
into place under the
ribs in the bag
cavity. Tuckfilter in
so that it fits
completely under
the rubber retainer.
4. Replace the bag as outlined in the BAG
CHANGING section (page 20).
21
To Next Page
Loading...
Need help?
General
