Kenmore 116.21614 User Manual

LIGHT BULBCHANGING
,_WARNING
Electrical Shock Or Personal injury
Hazard
Turn off and unplug vacuum €leaner
before performing maintenance to the
vacuum cleaner. Failure to do so cou]d
result in electrical shock or personal
injury from the vacuum cleaner
suddenly starting.
CAUTION '
Do not plug in or turn on until the vacuum
cleaner is completely reassembied.
ii
,_ CAUTION
Do not use a bulb rated over 9W
(13V). During extended use, heat from
the bulb could overheat surrounding
plastic parts.
NOTE: Use replacement bulb number 20-
5248, see part number detail in REPLACE-
MENT PARTS [page 6).
1. Remove PowerMate cover as shown in
BELT CHANGING AND AGITATOR
CLEANING (page 23-24) section.
_--_Pull out to _ 2. Remove the light
left sidi_ ._ bulb by pulling
_ straight out.
I 3. To replace the
Push
to rlghtin |1 light bulb, care-
fully insert fully
into slat.
4. Reinstall
PowerMate cover
as shown in BELTCHANGING AND
AGITATOR CLEANING (page 23-24)
section.
AGITATOR SERVICING
E
_kWARNING
Electrical Shock Or Personal lnjury
Hazard
Always turn off and unplug vacuum
cleaner before performing maintenance
to the vacuum cleaner. Failure to do so
could result in electrical shock or personal
injury from vacuum cleaner suddenly
starting.
New Brushes Worn Brushes
Basu
Support
Bar
TO CHECK THE BRUSHES
When brushesare worn to the level of the
base support bars, replace the agitatar
assembly.
TO REPLACEAGITATOR
ASSEMBLY
1. Remove PowerMate cover, belt and
agitator assembly. See "To Remove Belt" in
BELTCHANGING AND AGITATOR
CLEANING (page 23-24).
2. Replace agitator assembly. See your
separate repair parts list for part number.
3. Reinstall belt and PowerMate cover. See
"To replace belt" in BELTCHANGXNG AND
AGITATOR CLEANING (page 23-24).
25

Kenmore 116.21614 Specifications

General

Brand	Kenmore
Model	116.21614
Category	Vacuum Cleaner
Language	English