SECTION 2. PREPARE THE MACHINE FOR SEWING
= Wind the Bobbin {Continued)
f
Draw thread from spool through bobbin
winding tension disc as shown.
Pull end ol thread through
bobbin as shown.
J
hole in
7
J
Place bobbin onto bobbin winding
spindle with end of thread coming from
the top ot the bobbin. Push bobbin
winding spindle to the right until it clicks.
Holding onto end of thread, start
machine. When bobbin is sfightly filled,
snip off end of thread.
Wind thread until winder stops.
Push bobbin winding spindle to the left
and clip thread. Remove bobbin.
Turn clutch knob away trom you while
holding hand wheel tor normal sewing
operation.
Insert the Bobbin into the Bobbin Case
Place bobbin in bobbin case
making sure thread leeds
clockwise and is coming from
bobbin as shown.
f
Pull thread through slot of case
as shown.
f
Pull thread under tension
spring and through the opening
as shown above. Pull 3 to 4
inches of thread trom bobbin.
Holding latch open, position
case into shuttle and release
latch.
f
%.. J
Case should lock into place
when latch is released.
10
To Next Page
Loading...
Need help?
General
