SECTION 5. CARE FOR THE MACHINE
Replacing the Light Bulb Cleaning the Machine
_=qJ J I
%* J
1. Unplug the machine and open the
lace covert
CAUTION! The light bulb could be
HOT. Protect your fingers
when you handle it.
To insure that your machine operates at its best, you need to keep the essential parts clean at all times.
The teed dogs and shuttle race areas can attract dust and lint. Your machine can become sluggish or knock loudly if a thread
is caught.
Check and clean those areas about every three'months under normal use.
If you sew frequently, clean more often.
Clean the Feed Dogs
f
Follow these directions:
2. Push the bulb up and turn the bulb
counter=clockwise to remove it.
3. Put the new bulb in by pushing it up
and turning it clockwise.
1. Unplug the machine. Remove
presser loot and needle. Using a
screw driver, remove needle plate.
2. Use a lint brush to clean the Iced
dogs.
3. Replace needle plate.
38
To Next Page
Loading...
Need help?
General
