Kenmore 385.12514 User Manual

SECTION 3. REARNTHE STITCHES
Sew a Button
Set the Machine
Stitrh S_it_t_, _;etector
Top thread tension
conl[OI i to 4 Stilch length control
any number (not
_ nece_ adjust)
Zigzag loot
Dam_ng plale
q
Use the darning plate tot button sewing (see p. 2__23.
t. Set the stitch selector at °"ci='"
2. Atign both holes ot the button with the slot of the toot and place the left hole ot
the button just below the needle point.
3. Lower the toot and turn the stitch selector to zigzag until the needle polnt
comes just above the right hole of the button,
4, Sew about five stitches and raise needle,
5. Set the stitch at "'ci=- again and sew a few stitches to lock thread.
f
J
To strengthen the shank, cut the
threads leaving a 20 cm (8-) tail Bring
the needle thread down through the
hole in the button and wind it around the
shank.
Draw the thread to the bottom side and
knot.
26

Kenmore 385.12514 Specifications

General

Brand	Kenmore
Model	385.12514
Category	Sewing Machine
Language	English