7
TELEPHONE CALLS
1 Select your desired zone and group ID.
• Alternatively, you can press the key programmed as Auto Telephone to
automatically search for a Telephone Repeater.
2 Press and hold the PTT switch for approximately 1 second to ensure a
connection.
• &RQÀUPWKDWWKHUHLVDGLDOWRQHDIWHU\RXUHOHDVHWKHPTT switch.
3 Place the call, following the instructions for making a DTMF call {page 9}.
4 When the called party responds, press the PTT switch and speak into the
microphone. Release the PTT switch to receive.
• Only one person can speak at a time (you cannot hear the other person’s voice
while you are pressing the PTT switch).
5 To end the call, press and hold the PTT switch, then press # or the key
programmed as Telephone Disconnect.
SCAN
Scan monitors for signals on the transceiver channels. While scanning, the
transceiver checks for a signal on each channel and only stops if a matching
signal is present. There are three types of scans available.
• Single Scan: Monitors the channels of only the currently selected zone. If set up to
scan the Priority channel, it will be scanned even if it is not in the zone.
• Multi Scan: Monitors the channels of every zone.
• List Scan:0RQLWRUVWKHFKDQQHOVZLWKLQWKHVSHFLÀHGUDQJHRI]RQHV,IVHWXSWRVFDQ
the Priority channel, it will be scanned even if it is not within any of the zones in the list.
To start/stop scanning, press the key programmed as Scan.
• “SCAN” and the XX icon appear on the display during scan.
• When a signal is detected, scan pauses at that channel. The transceiver will remain on
the busy channel until the signal is no longer present, at which time scan resumes.
Note: To use Scan, there must be at least 2 channels added to the scan sequence.
RECALL
During scan, you can recall the last zone and channel/group ID on which you
made a call by pressing the key programmed as CH/GID Recall. Scan will
remain paused on the Recall channel until you press the key again.
PRIORITY SCAN
If a Priority channel has been programmed, the transceiver will automatically
change to the Priority channel when a call is received on that channel, even if call
is being received on a normal channel.
• The XX icon appears on the display when the Priority channel is selected.
To Next Page
Loading...
Need help?
General
