15
Q Squelch Level
If a key has been programmed as Squelch Level, you can readjust your
transceiver’s squelch level:
1 Press the key programmed as Squelch Level.
• The XX icon appears on the display, along with the current squelch level.
2 Press / to select the desired squelch level from 0 to 9.
3 Press S or
to store the new setting.
KEY LOCK
Press the key programmed as Key Lock to lock the transceiver front panel keys.
• When any key is pressed while Key Lock is active, “LOCKED” momentarily appears on
the display.
Press the Key Lock key again to unlock the keys.
SIGNAL STRENGTH
The Signal Stength indicator shows the strength of received signals:
XXXX XXX XX X
Strong 6XIÀFLHQW Weak Very Weak
Aditionally, while receiving a call, press the key programmed as RSSI Indicator to
view the decibel level of the received signal.
• The display will show “RSSI” followed by a number. The number is the decibel level of
the received signal.
Press any key other than the PTT switch to return to the channel display.
PUBLIC ADDRESS (PA)
The PA system can only be used with an optional relay unit and external speaker.
1 Press the key programmed as Public Address to activate the Public Address
function.
• The XX icon appears on the display.
2 Press and hold the PTT switch, then speak into the microphone to make your
address through the external speaker.
3 Press the Public Address key again to exit Public Address.
HORN ALERT
The Horn Alert function can only be used with an optional relay unit.
Press the key programmed as Horn Alert to toggle the Horn Alert function ON or
OFF.
• The XX icon appears on the display while Horn Alert is activated.
To Next Page
Loading...
Need help?
General
