Kenwood TK-863G User Manual

9
PLACING A TELEPHONE CALL
Note: You can only make a telephone call if the telephone service is available and you have an
optional keypad microphone. Refer to “DTMF (DUAL TONE MULTI FREQUENCY) CALLS” on
page 13. Consult your dealer for further details.
1 Select your desired system and group using the System and Group keys.
2 Press and hold the PTT switch for approximately 1 second to ensure a
connection.
• Confirm that there is a dial tone after releasing the PTT switch.
3 Dial a number using the microphone keypad.
• After dialing, wait for a response from the called party.
4 When the called party responds, press and hold the PTT switch, then speak
into the microphone. Release the PTT switch to receive.
• Only one person can speak at a time.
5 To end the call, press the # key or the key programmed as Telephone
Disconnect.
RECEIVING A TELEPHONE CALL
1 Select your desired system and group using the System and Group keys.
(If the Scan function has been programmed, you can switch it ON or OFF
as desired.)
•A ringing tone will sound when a call is received.
2 Press and hold the PTT switch when speaking and release it to listen.
• Only one person can speak at a time.
3 To end the call, press the # key or the key programmed as Telephone
Disconnect.

Kenwood TK-863G Specifications

Receiver Specifications

sensitivity (12 dB SINAD) wide	0.28 µV
sensitivity (12 dB SINAD) narrow	0.35 µV
selectivity wide	80 dB
selectivity narrow	65 dB
intermodulation distortion wide	75 dB
intermodulation distortion narrow	63 dB
spurious response	85 dB
audio output	4 W at less than 5% distortion

Transmitter Specifications

RF power output	25 W
spurious	65 dB
FM noise wide	50 dB
FM noise narrow	45 dB
modulation wide	16K0F3E
modulation narrow	11K0F3E
audio distortion	Less than 3%

General Specifications

frequency range	450 ~ 490 MHz
number of systems	Max. 32
number of groups	Max. 250
number of channels (conventional mode)	Max. 600
channel spacing wide	25kHz
channel spacing narrow	12.5kHz
channel step	5kHz, 6.25kHz
channel spread	40 MHz
current drain standby	Less than 0.4A
current drain receive	Less than 1.0A
current drain transmit	Less than 8.0A
RF input impedance	50 Ω
operating voltage	13.6 V DC±20%
operating temperature range	-22°F~ +140°F (-30°C ~ +60°C)
frequency stability	±2.5 ppm (-22°F ~ +140°F )
dimensions (W x H x D)	5.51 x 1.57 x 5.70 in (140 x 40 x 145 mm)
weight (net)	2.07 Ib (940 g)
FCC ID	ALH29383110
FCC compliance	FCC parts 22, 74, 90, 95