Kenwood TK-863G User Manual

12
■ Scan Revert
You can select revert systems and groups using the System and Group keys.
Four types of Scan Reverts can be programmed by your dealer:
• Last Called Revert: The last system/ group received is assigned as the
new revert system and group.
• Last Used Revert: The last system/ group responded to is assigned as
the new revert system and group.
• Selected: The last system/ group selected is assigned as the new revert
system and group.
• Selected + Talkback: If the system/ group has been changed during
Scan, the newly selected system/ group is assigned as the new revert
system and group. The transceiver “talks back” on the current receive
group.
GROUP SCAN
Group Scan is available for both trunked and conventional systems. This feature
is useful when more than one group is programmed in a system. Group Scan is
set by your dealer on request. It scans the revert groups as well as groups that
are allowed to be scanned.
When a call is received, the group indicator shows the group number, and that
group becomes the revert group. Simply press and hold the PTT switch, then
speak into the microphone to respond to the call.
You can also perform Group Scan while using a priority group. Please contact
your dealer for information concerning Priority Scan.

Kenwood TK-863G Specifications

Receiver Specifications

sensitivity (12 dB SINAD) wide	0.28 µV
sensitivity (12 dB SINAD) narrow	0.35 µV
selectivity wide	80 dB
selectivity narrow	65 dB
intermodulation distortion wide	75 dB
intermodulation distortion narrow	63 dB
spurious response	85 dB
audio output	4 W at less than 5% distortion

Transmitter Specifications

RF power output	25 W
spurious	65 dB
FM noise wide	50 dB
FM noise narrow	45 dB
modulation wide	16K0F3E
modulation narrow	11K0F3E
audio distortion	Less than 3%

General Specifications

frequency range	450 ~ 490 MHz
number of systems	Max. 32
number of groups	Max. 250
number of channels (conventional mode)	Max. 600
channel spacing wide	25kHz
channel spacing narrow	12.5kHz
channel step	5kHz, 6.25kHz
channel spread	40 MHz
current drain standby	Less than 0.4A
current drain receive	Less than 1.0A
current drain transmit	Less than 8.0A
RF input impedance	50 Ω
operating voltage	13.6 V DC±20%
operating temperature range	-22°F~ +140°F (-30°C ~ +60°C)
frequency stability	±2.5 ppm (-22°F ~ +140°F )
dimensions (W x H x D)	5.51 x 1.57 x 5.70 in (140 x 40 x 145 mm)
weight (net)	2.07 Ib (940 g)
FCC ID	ALH29383110
FCC compliance	FCC parts 22, 74, 90, 95