Kenwood TK-863G User Manual

11
SYSTEM SCAN
If the Scan function is programmed, you can scan the systems by pressing the
key programmed as Scan. When the Scan key is pressed, the SCN indicator
and either “-SCAN-” or the revert system/ group number appear on the display
and scanning starts. The systems not locked out of the scanning sequence are
scanned.
When a call is received, scanning stops and the system and group digits appear.
Press and hold the PTT switch, then speak into the microphone to respond to the
call. The transceiver will continue scanning after an adjustable time delay if the
PTT switch is released and no further signal is received.
■ Scanning Trunked Systems
When scanning trunked systems, the revert groups and the groups not
locked out of the scanning sequence are scanned. See “GROUP SCAN” on
page 12.
■ Scanning Conventional Systems
When scanning conventional systems, the revert groups and the groups not
locked out of the scanning sequence are scanned. See “GROUP SCAN” on
page 12.
■ Scan Lockout
If a key is programmed with Scan Del/Add, each system can be locked out of
the scan sequence manually. The delete indicator (s) will appear on the left
of the display when the selected system is locked out.
SCAN

Kenwood TK-863G Specifications

Receiver Specifications

sensitivity (12 dB SINAD) wide	0.28 µV
sensitivity (12 dB SINAD) narrow	0.35 µV
selectivity wide	80 dB
selectivity narrow	65 dB
intermodulation distortion wide	75 dB
intermodulation distortion narrow	63 dB
spurious response	85 dB
audio output	4 W at less than 5% distortion

Transmitter Specifications

RF power output	25 W
spurious	65 dB
FM noise wide	50 dB
FM noise narrow	45 dB
modulation wide	16K0F3E
modulation narrow	11K0F3E
audio distortion	Less than 3%

General Specifications

frequency range	450 ~ 490 MHz
number of systems	Max. 32
number of groups	Max. 250
number of channels (conventional mode)	Max. 600
channel spacing wide	25kHz
channel spacing narrow	12.5kHz
channel step	5kHz, 6.25kHz
channel spread	40 MHz
current drain standby	Less than 0.4A
current drain receive	Less than 1.0A
current drain transmit	Less than 8.0A
RF input impedance	50 Ω
operating voltage	13.6 V DC±20%
operating temperature range	-22°F~ +140°F (-30°C ~ +60°C)
frequency stability	±2.5 ppm (-22°F ~ +140°F )
dimensions (W x H x D)	5.51 x 1.57 x 5.70 in (140 x 40 x 145 mm)
weight (net)	2.07 Ib (940 g)
FCC ID	ALH29383110
FCC compliance	FCC parts 22, 74, 90, 95