36 EOC-BA-e-1610
7.10 Automatic adding-up
With this function the individual weighing values are automatically added into the
summation memory when the balance is unloaded without pressing and
edited, when an optional printer is connected.
„P2 COM“ „MODE“ „AUto““, see chap. 8.2
Add up:
Place load A.
After the standstill control sounds a signal tone. The
weighing value will be added to the summation memory
and printed. „ACC 1“ will be displayed shortly, then the
weighing value will be displayed.
(example)
Remove the load. More loads can only be added when
the display ≤ zero.
Place load B.
After the standstill control sounds a signal tone. The
weighing value will be added to the summation memory
and printed. „ACC 2“ will appear briefly, followed by the
weighing value.
Add more loads as described before.
Please note that the weighing system must be unloaded
between the individual weighing procedures.
This process may be repeated 99 times or till such time
as the capacity of the weighing system has been
exhausted.
Display and delete the weighing data, as well as printout example see chap.
To Next Page
Loading...
Need help?
General
