14 FKB-BA-e-2010
7 Unpacking, Setup and Commissioning
7.1 Installation Site, Location of Use
The balances are designed in a way that reliable weighing results are achieved in
common conditions of use.
You will work accurately and fast, if you select the right location for your balance.
Therefore, observe the following for the installation site:
• Place the balance on a firm, level surface.
• Avoid extreme heat as well as temperature fluctuation caused by installing next
to a radiator or in the direct sunlight.
• Protect the balance against direct draughts due to open windows and doors.
• Avoid jarring during weighing;
• Protect the balance against high humidity, vapours and dust.
• Do not expose the device to extreme dampness for longer periods of time. Non-
permitted condensation (condensation of air humidity on the appliance) may
occur if a cold appliance is taken to a considerably warmer environment. In this
case, acclimatize the disconnected appliance for ca. 2 hours at room
temperature.
• Avoid static charge of goods to be weighed or weighing container.
If electro-magnetic fields or static charge occur, or if the power supply is unstable major
deviations on the display (incorrect weighing results) are possible. In that case, the
location must be changed.
7.2 Unpacking and checking
Remove device and accessories carefully from packaging, remove packaging material
and install the device at the planned work place. Check if that there has been no
damage and that all packing items are present.
Scope of delivery / serial accessories:
• Balance, see chap. 3.1
• Mains adapter
• Operating manual
• Protective cover
• Flush-mounted hook
To Next Page
Loading...
Need help?
General
