FKB-BA-e-2010 21
9 Operating concept
From factory the balance is delivered with various applications (normal weighing, check
weighing, counting). After the first start-up the balance is in the <Weighing> application.
In the application menu (see chap.13.2.) however, you can define, selecting an
application, in which mode the balance after switching-on has to continue working.
Either as per standard in weighing mode or e.g. as check balance or counting balance
Note: The number of the installed applications depends on the model.
Selecting an application:
Press the TARE button and keep it pressed until the first menu item will be
displayed
Use the TARE button to select the menu setting < mode > and acknowledge with
button. The current setting will be displayed.
Use the TARE button to select the desired mode, selectable
weig h
Weighing mode
count
Counting mode
check
Check mode
Confirm with button.
According to the selected application in the application menu just appear the
application-specific settings, so that you reach the target quickly without detour.
• Information about the application-specific settings you will find in the
description of the respective application.
• All basic settings and parameters, which influence the whole operation of
the balance, are resumed in the Setup Menu (see chap.13.3.).
These settings remain valid for all applications.
Change application:
Press the TARE and ON/OFF button at the same time and keep them pressed
until the first menu item of the setup menu will be displayed
Use the TARE button to select the menu setting < mode > and acknowledge with
button. The current setting will be displayed.
Use the TARE button to select the desired mode and acknowledge
with button.
To Next Page
Loading...
Need help?
General
