FKB-BA-e-2010 19
8 Basic Operation
8.1 Turn on/off
Start-up:
Press the ON/OFF button.
The display lights up and the balance carries out a selftest.
Wait until the weight display appears, then the balance is ready for weighing.
Switch off:
Keep ON/OFF button pressed until the display disappears
8.2 Simple weighing
Check zero display [>0<] and set to zero with the help of the TARE–key, as
required.
Place goods to be weighed on balance.
Wait until the stability display appears ( ).
Read weighing result.
Overload warning
Overloading exceeding the stated maximum load (max) of the device,
minus a possibly existing tare load, must be strictly avoided. This could
damage the instrument. Exceeding the maximum load is indicated by
. Unload balance or reduce preload.
8.3 Weighing with tare
8.3.1 Taring
The dead weight of any weighing container may be tared away by pressing a button, so
that the following weighing procedures show the net weight of the goods to be weighed.
Put the weighing container on the weighing pan
Wait until the stability display appears ( ), then press TARE key.
The weight of the container is now internally saved. The zero display and the
indicator „TARE“ will appear. „TARE“ informs that all shown weight values are net
values.
Weigh the material.
Wait until the stability display appears ( ).
Read net weight.
To Next Page
Loading...
Need help?
General
