(1) P.T.O Shaft Cover (2) P.T.O Shaft Cap
WHEN OPERATING THE P.T.O
1. Make sure the tractor is completely
stopped, gears are in neutral and
all moving components have com-
pletely stopped before connecting,
disconnecting, adjusting, clean-
ing or servicing any P.T.O driven
equipment.
2. Keep the P.T.O shaft cover in place
at all times. Replace the P.T.O shaft
cap when the shaft is not in use.
3. Before installing or using P.T.O
M46O103A
driven equipment, read the work-
shop manual and review the safety
labels attached to the equipment.
WARNING
Before driving an implement
through the PTO, always make
sure that all bystanders are
well away from the tractor.
When using the PTO drive with
a stationary tractor, always
make sure that the gears are
in neutral and that the parking
brake is applied.
Before starting up any PTO-
driven implement hitched to
the three-point linkage, lift the
implement to its full height and
check that at least 1/4 of the
total length of the telescopic
section of the drive shaft is en-
gaged.
Ensure that implements and
attachments are properly in-
stalled and that the tractor and
implement PTO RPM ratings
match.
T66O122A
4. When operating stationary P.T.O
driven equipment, always apply
the tractor parking brake and place
chocks behind and in front of the
rear wheels. Stay clear of all rotat-
ing parts.
5. Do not attach a P.T.O dirven imple-
ment if the implements safety
shields are damaged or not in
place. Rotating shafts are an en-
tanglement hazard.
To Next Page
Loading...
Need help?
General
