15
kobalttools.com
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Air leak near the top of
the tool or in the trigger
area.
1. Loose screws. 1. Tighten screws.
Air leak near the
bottom of the tool.
1. Loose screws. 1. Tighten screws.
Tool does not operate
or operates sluggishly.
1. Inadequate air supply. 1. Verify adequate air supply.
Tool jams frequently. 1. Incorrect fasteners.
2. Damaged fasteners.
3. Loose magazine.
4. Dirty magazine.
1. Verify that fasteners are the correct
size.
2. Replace fasteners.
3. Tighten screws.
4. Clean magazine.
If you have any questions regarding the product, please call customer service at 1-888-3KOBALT
(1-888-356-2258), 8:00 a.m. - 8:00 p.m., EST, Monday - Friday.
TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
