Kobalt SGY-AIR88TZ User Manual (English)

Questions and Answers:

G
gilbertcourtneyAug 12, 2025
How to fix improper spray pattern Kobalt SGY-AIR88TZ Paint Sprayer?
- F
  fmaldonadoAug 12, 2025
  An improper spray pattern with your Kobalt Paint Sprayer can stem from several issues. It could be due to the gun being improperly adjusted, so carefully re-adjust it following the instructions. A dirty air cap can also cause this, so ensure you clean it thoroughly. Another potential cause is an obstructed fluid tip, which would also require cleaning. Lastly, a sluggish needle might be the culprit, in which case you should lubricate it.
D
Dillon HarrisAug 16, 2025
What to do if Kobalt Paint Sprayer will not spray?
- E
  Eric RamirezAug 16, 2025
  If your Kobalt Paint Sprayer isn't spraying, several factors could be at play. First, check that there is air pressure at the gun and that the air lines are in working order. If you're using an internal mix cap and pressure tank, the fluid pressure might be too low, so increase the fluid pressure at the tank. Also, ensure the fluid control screw is open enough. If the fluid is too heavy for suction feed, thin the material or switch to a pressure feed system.
A
Amanda JamesAug 20, 2025
Why is my Kobalt SGY-AIR88TZ dripping from fluid tip?
- B
  Brandi HollowayAug 20, 2025
  Dripping from the fluid tip of your Kobalt Paint Sprayer can occur for a few reasons. Dry packing could be the cause, so try lubricating it. A sluggish needle can also lead to dripping, so lubricating it is recommended. Check if the packing nut is too tight and adjust it accordingly. Lastly, a worn fluid nozzle or needle may be the issue; if you're using pressure feed, replace them with new ones.