TP-6195 1/04 37Section 6 Installation
6.11 Controller Configuration
6.11.1 System Configuration
The system configuration is factory-set and should not
normally require changes in the field. However, the
controller’s configuration modes allow setting of the
system voltage/frequency and adjustment of the output
voltage and frequency after reconnection. Have
reconnection and the related adjustments performed by
an authorized distributor/dealer or service technician.
The unit configuration and engine type are factory-set
for each type of generator set and engine, and should
not be changed in the field.
6.11.2 Advanced Configuration Mode
The controller’s advanced configuration mode allows a
technician to set the data input type for different
senders, change the battery voltage to 12 or 24 VDC if
the battery voltage is changed in the field, and change
the controller communications setting for field-installed
meters. Have these adjustments performed by an
authorized distributor/dealer or service technician.
6.12 Prestart Installation Check
Review the entire installation section. Inspect all wiring
and connections to verify that the generator set is ready
for operation. Check that there are no obstructions to
the air inlet and outlet. Check all items in the Prestart
Checklist. See Section 2.1.
6.13 Warranty Registration
Complete the startup procedure and installation
checklists supplied with the startup notification form.
Return the form to the distributor/dealer or mail it directly
to:
Kohler Power Systems
Generator Warranty Administrator
M.S. 072
Kohler, Wisconsin 53044
To Next Page
Loading...
Need help?
General
